SM16714 Pixel Protocol

A single-wire, self-clocking RGBW pixel chip with an integrated 8-bit-per-channel driver IC in a SOP8 package, daisy-chained over one data line.

Specifications

Clock TypeData-Only
Color Resolution8 Bits
Physical PackageSOP8
RGBNo
RGBWYes
Output Pixel Voltage5 - 15V
PWM Rate1000Hz
Suitable CameraUp to 34fps
Redundant Data LineNo

Strengths

  • Single self-clocking data line keeps wiring simple: there is no separate clock conductor to route, so cabling, connector count and EMI exposure stay lower than on two-wire clocked chips.
  • RGBW output adds a dedicated white channel alongside red, green and blue at 8 bits per channel, giving cleaner whites and pastels than an RGB-only chip can mix.
  • Wide 5 to 15V pixel supply supports higher-voltage strings, reducing voltage drop and the number of power-injection points over longer runs than 5V-only parts.

Limitations

  • No redundant data line: a single failed pixel or broken data joint blanks everything downstream, so critical installs need spare-run or reverse-feed planning.
  • 8 bits per channel with a 1000Hz PWM refresh is adequate for the rated 34fps but leaves little margin for very slow high-speed cinematography or deep low-end dimming; it is a mid-range part, not a high-speed film chip.

Overview

The SM16714 is a data-only, single-wire addressable pixel driver: each LED carries an integrated IC that latches its own RGBW value from one self-clocking data line and forwards the rest down the chain. It drives red, green, blue and white at 8 bits per channel across a 5 to 15V pixel supply, with a 1000Hz PWM refresh that is comfortably flicker-free for the rated capture up to 34fps. There is no redundant data line, and the package is SOP8. ENTTEC pixel controllers (OCTO 71521, PIXELATOR MINI and MK2 70067/70068, DIN PIXIE 73539, PLINK Injectors) drive many pixel protocols; contact ENTTEC about chips not listed.

Compatible ENTTEC controllers

OCTO
OCTO

Sku: 71521

DIN PIXIE
DIN PIXIE

Sku: 73539

PIXELATOR MINI
PIXELATOR MINI

Sku: 70067

PLink Injector
PLink Injector

Sku: 73-545

ENTTEC has been engineering lighting control in Australia since 1999, and shipping LED pixel controllers since the original Pixelator in 2014.